Gradall 534D10-45 Telescopic Telehandler

2005 Gradall 534D 10-45 Telescopic Telehandler, John Deere Diesel Turbocharged Engine, 115 HP, Hydrostatic Drive, Certified ROPS & FOPS, Hydraulic Power Steering, Switchable 2WD & 4WD, 4,116 hours.

Performance

• Rated Capacity: At 24 in. load center, 10,000 lb.
• Maximum Lift Height: 45 ft.
• Frame Leveling: 8 Degrees
• Lift Speed (Boom Retracted): Up - 10.8 Sec | Down - 8.1
• Boom Speed: Extend - 14.5 sec | Retract - 13.5 sec
• Travel Speeds Forward: 2WD 0-19 mph | 4WD 0-6.5 mph
• Drawbar Pull (Loaded): 21,000 lb.
• Operating Weight: With 48 in. carriage and forks, 25,300 lb.

Standard Specifications

Engine

• Make: John Deere
• Model: 4045TF275
• Aspiration: Trubocharged
• Fuel: No. 2 Diesel
• Cycles: 4
• Cylinders: 4
• Displacement: 4.5 L
• Rated Speed: 2,500 rpm
• Max. Gross BHP: 115 hp
• Fuel Tank: 38 gal

Engine Filters

Two-stage dry air cleaner — centrifugal pre-cleaner with continuous dust ejector plus replaceable dry filter element. Visual service indicator. Replaceable spin-on fuel filter. Full-flow replaceable spin-on engine oil filter.

Electrical System

• Voltage: 12V
• Alternator: 65 amp
• Battery: 1050 cold cranking amps at 0°F

Hydrostatic Drive

6,300 PSI (43,437 kPa) closed loop with piston pump and motors. All hydraulic connections ORS and Code 62 O-ring flanges.  Integral reservoir with implement hydraulics. 8 micron suction filter for charge pump. Self-contained, swashplate design, variable displacement, over center, piston pump. Neutral start switch. (Park brake must also be engaged to start.) 2WD — 4WD inching. Audible back-up travel alarm mounted in counterweight area signals reverse movement.

Axles

Planetary hubs with piston motors on rear axle. Piston motor-driven planetary front axle with high-bias differential.

Service Brakes

Hydraulic wet disc brake on each front wheel. Hydraulic dynamic braking on front axle and both rear wheels.

Parking Brakes

Wet disc spring-applied electro/hydraulic release, fail-safe on both front wheels. Light on dash indicates when brakes are on. Frame mounted right side rear view mirror.

Tires

• Standard: 14:00 x 24 — 12PR, G2 type.

Cab

Certified ROPS/FOPS structure with horn, back-up alarm and standard right side rear view mirror. Forward, neutral, reverse lever on left of steering column. Single foot pedal control provides both braking and inching for lifting while maneuvering vehicle. Electro/hydraulic traction lock valve for superior tractive effort.

Steering

Hydraulic power steering with manual backup. Rear wheel steering, 90° pivot around either front tire. Outside turning radius is less than chassis length.

Instruments

Volt meter, hourmeter, engine oil pressure, temperature, fuel gauge. All gauges protected by clear acrylic cover.

Controls

Grouped for operator comfort and convenience. 2WD and 4WD switch on dash. Boom lift and crowd on single joystick. Right-hand tilt and sway lever. Foot throttle. Floor mounted traction lock switch.

Hydraulic System-Implement

Single-section gear pump. 40 gal system capacity. 8 micron filter with visual service indicator and suction strainer. Lift, crowd, tilt and sway cylinders have safety checks to prevent dropping of load in the event of hose or other hydraulic failure.

Auxiliary Hydraulics

Used for all attachments equipped with cylinders or other hydraulic components. Consists of valves, controls and hydraulic lines.